Rigg Leather Ratchet Belt

• Material: 100% Leather
• Adjustable ratchet design - one size fits all

• Total leather length (from tip to buckle end): 122cm
• Adjustable ratchet track length: 19.3cm
• Belt width: 3.5cm

Adjusting Your Ratchet Belt

You'll need: scissors or a sharp craft knife, a ruler/tape, and a pen/pencil:

1. Release the buckle

Flip open the small latch on the underside of the buckle and slide the leather strap out.

2. Measure & mark

Work from the buckle end only (the end without the ratchet track). Put the belt on to guage your fit, then mark the amount to remove. Start conservatively (e.g., 1-2 cm at a time).

3. Cut the strap

Cut straight across your mark at the buckle end.

4. Reattach

Insert the freshly cut end back into the buckle until fully seated, then close the latch so the teeth grip and secure the leather.

5. Test & fine-tine

Try the belt on and adjust to your preferred notch-free fit. If it's still a touch long, repeat steps 2-4, trimming a little more.

Quick tips:

• Always cut from the buckle end, never the end with the ratchet track
• Trim in small increments - you can always take more off, but you can't add it back.